Sets the specified port‘s internal configuration state to INVALID.
| eapsDomain | Specifies the name of an EAPS (Extreme Automatic Protection Switching) domain. |
| primary | Specifies that the primary port should be unconfigured. |
| secondary | Specifies that the secondary port should be unconfigured. |
N/A.
Unconfiguring an EAPS port sets its internal configuration state to INVALID, which causes the port to appear in the Idle state with a port status of Unknown when you use the show eaps detail command to display the status information about the port.
Enter y to unconfigure the specified port.
Enter n or press [Return] to cancel this action.
If you have considerable knowledge and experience with EAPS, you might find the EAPS loop protection warning messages unnecessary. For more information, see the configure eaps config-warnings off.
The following command unconfigures this node‘s EAPS primary ring port on the domain eaps_1:
unconfigureeapseaps_1primary port
The switch displays the following warning message and prompts you to confirm this action:
WARNING: Unconfiguring the Primary port from the EAPS domain could cause a loop in the network! Are you sure you want to unconfigure the Primary EAPS Port? (y/n)Enter y to continue and unconfigure the EAPS primary ring port. Enter n to cancel this action.
The switch displays a similar warning message if you unconfigure the secondary EAPS port.This command was first available in ExtremeXOS 11.0.
The interactive messages were added in ExtremeXOS 11.4.
Print
this page
Email this topic
Feedback
View PDF
Download EPUB