Enables synchronous Ethernet (SyncE) on port(s).
port_list |
Specifies a port or group of ports. |
all |
Specifies all ports. |
Disabled.
Use this command to enable SyncE on one or more ports.
If you attempt to enable SyncE on a port or ports that are not supported, one of the following messages is displayed:
ERROR: Cannot enable Synchronous Ethernet on ports ERROR: Cannot enable Synchronous Ethernet on some/all ports
To disable SyncE, use the disable network-clock sync-e command.
To display SyncE settings, use the show network-clock sync-e ports command.
The following command enables SyncE on port 2:
enable network-clock sync-e port 2
This command was first available in ExtremeXOS 15.1.
This command is available on the Summit X460-G2 series switches.