This command allows you to configure a value for the minimum number of active links to keep the entire LAG (Link Aggregation Group) up.
| sharing | Load sharing. |
| port | Master port. |
| minimum-active | Minimum active links for group to remain in service. |
| min_links_active | Number of active links. Default is 1. Range is 1 – 8. |
1
Use this command to configure the value for the minimum number of active links to keep the LAG up.
The following example display output from the show port port sharing command using minimum active links:
Print
this page
Email this topic
Feedback
View PDF
Download EPUB# sh ports 14 sharing
Load Sharing Monitor
Config Current Agg Min Ld Share Ld Share Agg Link Link Up
Master Master Control Active Algorithm Group Mbr State Transitions
==============================================================================
14 Static 2 L2 14 - R 0
L2 15 Y A 1
L2 16 - R 0
==============================================================================
Link State: A-Active, D-Disabled, R-Ready, NP-Port not present, L-Loopback
Minimum Active: (<) Group is down. # active links less than configured minimum
Load Sharing Algorithm: (L2) Layer 2 address based, (L3) Layer 3 address based
(L3_L4) Layer 3 address and Layer 4 port based
(custom) User-selected address-based configuration
Custom Algorithm Configuration: ipv4 L3-and-L4, xor
Number of load sharing trunks: 2 (1 displayed)
This command was first available in ExtremeXOS 15.7.
All ExtremeXOS-based platforms that support static LAG and LACP are supported.