This command clears the accumulated PTP packet counters. The clear can be performed on the following groups:
Per unicast-master or unicast-slave peer on a clock port.
Peers on a clock port.
Peers on all clock ports.
Note
This command is available only for Boundary and Ordinary clocks.
network-clock | External Clock for Ethernet synchronization. |
ptp | Precise Time Protoco.l |
boundary | Boundary clock. |
ordinary | Ordinary clock. |
vlan | VLAN (Virtual LAN). |
ipv4_address | Peer IP address. |
unicast-master | IP addresses that are masters to the local clock. |
unicast-slave | IP addresses that are slaves to the local clock. |
all | All VLAN. |
counters | PTP message counts. |
N/A.
Use this command to clear the accumulated PTP packet counters.
N/A.
This command was first available in ExtremeXOS 15.2.
This command is only available on boundary and ordinary clocks on Summit X460-G2, X670-G2, and X770 series switches.
Note
PTP commands can be used only with the Network Timing feature pack.