Show the unicast slave table of the specified clock port, or all clock ports. This command is only available for boundary clocks.
boundary | Specifies the boundary clock. |
unicast-slave | Specifies table of unicast masters. |
vlan | VLAN (Virtual LAN). |
vlan_name | VLAN name. |
vlan all | Specifies all vlans. |
N/A.
Use this command to display the unicast master table of the specified clock port or all clock ports. This command is only available for boundary clocks.
The following command displays the unicast master table for all clock ports:
# show network-clock ptp boundary unicast-slave vlan all VLAN Name IP Address ptp-m1 7.1.1.1 ptp-m1 7.1.2.1 ptp-m1 88.3.5.1
This command was first available in ExtremeXOS 15.1.
This command is available on the Summit X460-G2, X670-G2, and X770 series switches.
Note
PTP commands can be used only with the Network Timing feature pack.