Configures monitoring for each member port of a health check LAG (Link Aggregation Group).
|
port |
Specifies the member port. |
|
IP Address |
Specifies the IP address to monitor. |
|
TCP Port |
Specifies the TCP port to watch. The default is port 80. |
|
sec |
Specifies the frequency in seconds at which tracking takes place. The default is 10 seconds. |
|
count |
Specifies the number of misses before a connection loss is reported. The default is 3 misses. |
N/A.
To configure a health check LAG, you first create a health check type of LAG using the enable sharing grouping command. Then use this command to configure the monitoring for each member port. You can configure each member port to track a particular IP address, but only one IP address per member port.
To display the monitoring configuration for a health check LAG, use the show sharing health-check command.
To display the link aggregation configured on a switch, use the show ports sharing command.
The following commands configure four different member ports:
# configure sharing health-check member-port 10 add track-tcp 10.1.1.1 tcp-port 23 # configure sharing health-check member-port 11 add track-tcp 10.1.1.2 tcp-port 23 # configure sharing health-check member-port 12 add track-tcp 10.1.1.3 # configure sharing health-check member-port 13 add track-tcp 10.1.1.4
When the TCP port, seconds, or counts are not specified, they default to the values described in the Syntax Description.
This command was first available in ExtremeXOS 12.1.3.
Print
this page
Email this topic
Feedback
View PDF
Download EPUB