Enables BOOTP Relay v6. This can be done across the VR or on a per VLAN (Virtual LAN) basis.
bootprelay | BOOTP Relay service. |
ipv4 | DHCPv4 BOOTP Relay service. |
ipv6 | DHCPv6 BOOTP Relay service. |
vlan_name | Specifies a VLAN name |
vr | Uses a specific virtual router name. |
vr_name | Specifies a virtual router name. |
all | Enables all VLANs. |
IPv4.
Use this command to enable BOOTP Relay across the VR or on a per VLAN basis.
The following example displays IPv6 bootprelay information:
* switch # show bootprelay ipv6 BOOTP Relay: DHCPv6 BOOTP Relay enabled on virtual router "VR-Default" BOOTP Relay Servers : 2001:0db8:85a3:0000:0000:8a2e:0370:7334 2001:0db8:85a3:0000:0000:8a2e:0370:7335 2001:0db8:85a3:0000:0000:8a2e:0370:7336 2001:0db8:85a3:0000:0000:8a2e:0370:7337 VLAN "Default": BOOTP Relay : Disabled VLAN "v1": BOOTP Relay : Enabled BOOTP Relay Servers : 2001:0db8:85a3:0000:0000:8a2e:0370:7338 Interface ID : v1-12 Remote ID :v1_remId Prefix Snooping : Disabled VLAN"v2": BOOTP Relay : Enabled BOOTP Relay Servers : 2001:0db8:85a3:0000:0000:8a2e:0370:7339 Interface ID : 100 (Default) Remote ID : 00:04:96:52:A7:1B (Default) Prefix Snooping : Disabled
This command was first available in ExtremeXOS 15.5.
This command is available on platforms that support the appropriate license. For complete information about software licensing, including how to obtain and upgrade your license and which licenses support the PIM feature, see the ExtremeXOS 22.6 Feature License Requirements document.