Changes the labels of a statically configured Ethernet PW for a VPLS.
| vpls_name |
Specifies the VPLS for which you are configuring a peer. |
| peer |
Specifies the peer IP address. |
| ipaddress |
Specifies the IP address of the peer node. |
| static-pw |
Specifies the static pseudowire. |
| transmit label |
Specifies the pseudowire transmit label. |
| outgoing_pw_label |
Specifies the name of the egress label. |
| receive-label |
Specifies the static pseudowire receive label. |
| incoming_pw_label |
Specifies the name of the ingress label. |
N/A.
Use this command to change the labels of a statically configured Ethernet PW for a VPLS that already exists. Either or both the outgoing (MPLS (Multiprotocol Label Switching) ingress) and incoming (MPLS egress) PW labels can be specified. The peer must be similarly configured with a static PW that has the reverse PW label mappings. Locally, the incoming_pw_label must be unique and is allocated out of the static label space. The outgoing_pw_label must match the peer‘s configured incoming PW label. The CES or L2VPN can remain operational during the change; however, the PW will go down and come back up.
The following command changes the VPLS label to "VPLS1":
configure l2vpn vpls vpls1 peer static-pw 1.1.1.202
This command was first available in ExtremeXOS 15.4.
This command is available on all platforms that support MPLS as described in the ExtremeXOS 22.6 Feature License Requirements document.
Print
this page
Email this topic
Feedback
View PDF
Download EPUB