This command displays the endpoint configured values, run-time data, and test session information.
ipaddress | The endpoint IP address, either IPv4 or IPv6. |
ip | Specifies the endpoint IP address. |
port | Specifies the endpoint port. |
udp-port | The UDP port the endpoint will listen on; range is 1025 – 65535. |
N/A.
None.
# show twamp endpoint ipaddress 19.1.1.100 port 5000 TWAMP Endpoint Endpoint Information Local Address: 19.1.1.100 Listening Port: 5000 Received Packets: 7948 Transmitted Packets: 7948 Active Sessions: 5 Session created on Thu Nov 13 15:41:49 2014 Peer Address: 19.1.1.2 Port: 11001 Sequence Number: 1575 Last recv'd packet: 84ms Session created on Thu Nov 13 15:41:49 2014 Peer Address: 19.1.1.2 Port: 11002 Sequence Number: 1555 Last recv'd packet: 16ms Session created on Thu Nov 13 15:41:49 2014
This command was first available in ExtremeXOS 16.1.