run esvt traffic-test

run esvt traffic-test {vlan} vlan_name loopback-port loopback-port peer-switch-ip ipaddress packet-size packet_size rate rate [Kbps|Mbps |Gbps] duration time [seconds | minutes | hours]

Description

Runs the Extreme Service Verification tool on the specified ports of the VLAN (Virtual LAN) using the specified count and interval.

Syntax Description

vlan Specifies the VLAN for the traffic test.
vlan_name Specifies a VLAN name.
loopback-port Specifies the loopback port for the traffic test.
loopback-port Specifies the loopback-port.
peer-switch-ip Specifies the peer switch for the traffic test.
ipaddress Specifies the IP address of the peer switch.
packet-size Specifies the size of packet to use for service verification.
packet_size Specifies the size; the range is 64 - 9216.
rate Specifies the maximum service utilization rate and rate value.
Kbps Specifies K bits per second.
Mbps Specifies M bits per second.
Gbps Specifies G bits per second.
duration Specifies the duration of time to run service verification.
time Specifies the duration value; the range is 1-65534.
seconds Specifies the time in seconds.
minutes Specifies the time in minutes..
hours Specifies the time in hours.

Default

N/A.

Usage Guidelines

Use this command to run the Extreme Service Verification tool on the specified ports of the VLAN using the specified count and interval.

Example

The following example starts the Extreme Service Verification tool on vlan1, loopback port 2:

run esvt traffic-test v1 loopback-port 2 peer-switch-ip 2.2.2.2 packet-size 64 rate 200 Mbps duration 5 minutes    

History

This command was first available in ExtremeXOS 15.3.

Platform Availability

This command is available on Summit X450-G2, X460-G2, X670-G2, X770, ExtremeSwitching X440-G2, X620 series switches, and stacking.