Displays the L2PT configuration and status of a service.
vlan | Displays VLAN (Virtual LAN) configuration. |
vman | Displays VMAN configuration. |
vlan_name | Specifies a VLAN name. |
ports port_list | Displays the ports and port list separated by a comma ( , ) or dash ( - ). |
detail | Displays the L2PT configuration and status in detail. |
Disabled.
Use this command to display the L2PT configuration and status of a service.
The following is an example of the show vman ports l2pt command:
# show vman cust2 ports 1:2,1:7 l2pt Interface L2PT Profile Name --------------- -------------------------------- 1:2 my_l2pt_prof 1:7 (none)
The following example illustrates the show vman l2pt ports detail command:
show vman cust2 ports 1:2,1:7 l2pt detail Port 1:2 L2PT Profile Name : my_l2pt_profile Protocol Filter Name : filter1 Destination Address: 01:80:C2:00:00:02 Protocol Id Type : etype Protocol Id Value : 0x8902 Field Offset : 14 Field Value : 03 Field Mask : FF Action : Tunnel CoS : Default Packets Transmitted: 2300 Packets Received : 2300 Protocol Filter Name : filter2 Destination Address: 01:80:C2:00:00:00 Protocol Id Type : snap Protocol Id Value : 0x4041 Field Offset : Field Value : Field Mask : Action : Tunnel CoS : 7 Packets Transmitted: 500 Packets Received : 500 Port 1:7 L2PT Profile Name : (none)
This command was first available in ExtremeXOS 15.5.