Setting an Allowed Location Configuration

About this task

The Allowed Locations option is a means to control a user's access to locations (RF Domains/sites/tree-node paths) within your managed network. Use this option to configure an allowed-locations tag and associate one or more locations with the tag. After you have created an allowed-locations tag, use the Administrators screen to apply these tags to users.

Note

The allowed-locations tag is ONLY applicable to the WiNG 'Device Provisioning' user. By applying the allowed-locations tag, the device provisioning user will only be able to provision devices that fall within his/her purview of responsibility.

Note

However, if you are an NSight admin and you are using WiNG 5.9.2 and earlier version, you can apply the Allowed Locations tag for all NSight user roles.

Note

For information on user roles and how to configure them, see Configure Management User Account.

To set an allowed location configuration:

Procedure

Select the Allowed Locations tab.
The Allowed Location screen lists existing users and their permitted locations.
Review existing allowed location configurations.
Select Add to create a new allowed location configuration. To modify or delete an existing configuration, select it from the available list and click Edit or Deleterespectively.
The Allowed Locations window displays.

Set or modify the following allowed location parameters:

Name

If adding a new Allowed Locations configuration, provide a 32 character maximum name. Provide a name that identifies the associated locations (RF Domain).

Locations

Specify the RF Domain name in the Locations field and use the green, downward navigation arrow to move it below to the list of enabled locations. You can associate a single RF Domain or multiple RF Domains with an Allowed Locations tag. The location can also be specified as a Tree-node Path or multiple Tree-node Paths. Save and exit the screen to enable the locations tags. To remove an enabled location, select it from the enabled list and click the red, upward navigation arrow.

Click OK to update the allowed location configuration.
Click Reset to revert to the last saved configuration.