Profiles can utilize customized port channel configurations as part of
their interface settings. Existing port channel profile
configurations can be overridden as they become obsolete for
specific device deployments.
To define or override a port channel
configuration on a profile:
Procedure
Go to
Configuration → Devices.
The
Device Configuration screen displays. This
screen lists access points, controllers and service
platforms within the managed network.
Select a
target device by double-clicking on the device name.
Note
You can
also select the target device from the device browser in
the lower, left-hand, side of the UI.
The
selected device's configuration menu displays.
Go to
Profile Overrides → Interface → Port
Channels.
Profile Overrides - Port Channel Interface Main
Screen
Note
A blue
override icon (to the left of a parameter) defines the
parameter as having an override applied. To remove an
override go to the Basic
Configuration section of the device and
click Clear
Overrides. This removes all overrides
from the device.
Refer to the following to review
existing port channel configurations and their status to determine whether a
parameter requires an override:
Name
The port channel's numerical identifier assigned when it
was created. The numerical name cannot be modified as part
of the edit process.
Type
Whether the type is port channel.
Description
A short description (64 characters maximum) describing
the port channel or differentiating it from others with
similar configurations.
Admin Status
A green check mark means the listed port channel is
active and currently enabled with the profile. A red “X”
means the port channel is currently disabled and not
available for use. The interface status can be modified with
the port channel configuration as required.
After reviewing the configurations of existing port channel interfaces,
determine whether a new interface needs to be created, an existing interface
needs to be edited (overridden), or an existing interface needs to be
deleted.
