T5 Fast Ethernet Status

About this task

T5 controllers can have their connected CPE fe ports (1-2) analyzed for performance analysis. A single T5 controller can manage up ton 24 CPE devices and 48 fe ports.

CPE- fe1-fe2

To view T5 controller connected CPE fe port status:

Procedure

Select the Statistics menu from the Web UI.
Select the Wireless Controller node from the left navigation pane and select a T5 controller from amongst those displayed.

Select the Interface menu item and expand it to display it sub menu items. Select Fast Ethernet. Select the Status tab.

Review the following CPE fe port descriptions:


Name	Displays the name of the selected CPE fe Ethernet port.
Operational Status	Lists whether each Ethernet port link is currently up or down as a transmit and receive resource.
Duplex	Lists either half, full or automatic as the duplex. Half duplex sends data over the port, then immediately receive data from the same direction in which the data was transmitted. Like a full-duplex transmission, a half-duplex transmission can carry data in both directions, just not at the same time. Full duplex transmits data to and from the port at the same time. Using full duplex, the port can send data while receiving data as well. Automatic enables the controller to dynamically duplex as port performance needs dictate.
Speed (MB)	Lists each port's current speed in MB.
Pause	Lists whether pause packet utilization is currently off or on for the port.
Admin Status	Admin Status Displays whether each listed port had been placed in an enabled or disabled state by the administrator.

Select Refresh to update the screen's statistics counters to their latest values.