Using CLI to Set AP's Mode of Operation

About this task

To manually set the AP's mode of operation using its CLI:

Access the AP's CLI through SSH or console using default credentials.
Use the AP's Primary or Secondary (ZEROCONF) IP address to do an SSH.

Primary IP address - This is the DHCP provided IP address.

Secondary IP address - This is the ZEROCONF IP address '169.254. xx.yy'. Where, 'xx' and 'yy' are the last two octets of the AP's MAC address in decimal format. Note, the AP's MAC address will be printed on the box.
For example:

If AP's MAC address is: 00:C0:23:00:F0:0A

The secondary IP address will be: 169.254.240.10
You will be presented with the following message:
```
AP adoption discovery process in progress…
To cancel and boot in Standalone mode, type (s):  
```
Type 's' to move into the 'Standalone/WiNG' mode.
```
AP adoption discovery process in progress…
To cancel and boot in Standalone mode, type (s): s

AP booting in Standalone mode…  
```
The AP will reboot immediately. After reboot, you will be presented with the WiNG login prompt.
Use the following default credentials to login:

username: admin

password: admin123