show eapol port

Display Extensible Authentication Protocol (EAPoL) information for the specified port or interface type.

Syntax

show eapol port {slot/port[sub-port]}
show eapol port interface gigabitEthernet
show eapol port interface gigabitEthernet {slot/port[/sub-port][-slot/port[/sub-port]][,...]}
show eapol port interface vlan <1-4059>
show eapol port interface <1-4059> [{slot/port[/sub-port][-slot/port[/sub-port]][,...]}]

{slot/port[sub-port]}: Identifies a single slot and port. If your platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.
gigabitethernet {slot/port[/sub-port][-slot/port[/sub-port]][,...]}: Identifies the slot and port in one of the following formats: a single slot and port (slot/port), a range of slots and ports (slot/port-slot/port), or a series of slots and ports (slot/port,slot/port,slot/port). If your platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.
vlan <1-4059>: Specifies the VLAN ID in the range of 1 to 4059. By default, VLAN IDs 1 to 4059 are configurable and the system reserves VLAN IDs 4060 to 4094 for internal use. On switches that support the vrf-scaling and spbm-config-mode boot configuration flags, if you enable these flags, the system also reserves VLAN IDs 3500 to 3998. VLAN ID 1 is the default VLAN and you cannot create or delete VLAN ID 1.

None

User EXEC