mgmt dhcp-client

Specifies a DHCP Client configuration for management interfaces.

Syntax

Command Parameters

cycle
Specifies the DHCP Client to attempt to obtain an IP address on the In-Band VLAN management interface, then the Out-of-Band management interface. Cycle attempts until an IP address is obtained.
oob
Specifies the DHCP Client to obtain an IP address for the Out-of-Band management interface.
vlan
Specifies the DHCP Client to obtain an IP address for the In-Band VLAN management interface.

Default

The DHCP Client for management interfaces is disabled.
Note

Note

Exception: the DHCP Client is enabled by default in cycle mode when:
  • The switch ships directly from manufacturing with Fabric Engine Release 8.6 or later.

  • The primary and secondary configuration file is not on the switch.

  • The primary and secondary configuration file fail to load on the switch.

Command Mode

Global Configuration

Usage Guidelines

The cycle and oob parameters are not supported on 5320 Series.