auto-negotiate enable (on an Ethernet port)

Syntax

• auto-negotiate

• auto-negotiate enable

• auto-negotiate port {slot/port[/sub-port][-slot/port[/sub-port]][,...]}

• auto-negotiate port {slot/port[/sub-port][-slot/port[/sub-port]][,...]} enable

• default auto-negotiate

• default auto-negotiate enable

• default auto-negotiate port {slot/port[/sub-port][-slot/port[/sub-port]][,...]}

• default auto-negotiate port {slot/port[/sub-port][-slot/port[/sub-port]][,...]} enable

• no auto-negotiate

• no auto-negotiate enable

• no auto-negotiate port {slot/port[/sub-port][-slot/port[/sub-port]][,...]}

• no auto-negotiate port {slot/port[/sub-port][-slot/port[/sub-port]][,...]} enable

Command Parameters

enable

Enables or disables AutoNegotiation for the port or other ports of the module or both.

port {slot/port[/sub-port] [-slot/port[/sub-port]] [,...]}

Identifies the slot and port in one of the following formats: a single slot and port (slot/port), a range of slots and ports (slot/port-slot/port), or a series of slots and ports (slot/port,slot/port,slot/port). If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

Default

The default Auto-Negotation behavior depends on the switch model and transceiver type. For more information, see Fabric Engine User Guide.

Command Mode

GigabitEthernet Interface Configuration