ipv6 area virtual-link

Configure an OSPF virtual interface to the ABR if a remote OSPF ABR uses no connection to the backbone area but needs to be part of the same routing domain in which the switch resides.

Syntax

default ipv6 area virtual-link {A.B.C.D} {A.B.C.D}
default ipv6 area virtual-link {A.B.C.D} {A.B.C.D} dead-interval
default ipv6 area virtual-link {A.B.C.D} {A.B.C.D} hello-interval
default ipv6 area virtual-link {A.B.C.D} {A.B.C.D} retransmit-interval
default ipv6 area virtual-link {A.B.C.D} {A.B.C.D} transit-delay
ipv6 area virtual-link {A.B.C.D} {A.B.C.D}
ipv6 area virtual-link {A.B.C.D} {A.B.C.D} dead-interval <1-65535>
ipv6 area virtual-link {A.B.C.D} {A.B.C.D} hello-interval <1-65535>
ipv6 area virtual-link {A.B.C.D} {A.B.C.D} retransmit-interval <1-1800>
ipv6 area virtual-link {A.B.C.D} {A.B.C.D} transit-delay <1-1800>
no ipv6 area virtual-link {A.B.C.D} {A.B.C.D}

Command Parameters

{A.B.C.D} {A.B.C.D}: Specifies the area address and the virtual link address.
dead-interval <1-65535>: Specifies the dead interval, as the number of seconds to wait before determining the OSPF router is down. The default dead-interval is 60.
hello-interval <1-65535>: Specifies the hello interval, in seconds, for hello packets sent between switches for a virtual interface in an OSPF area. The default hello interval is 10.
retransmit-interval <1-1800>: Specifies the retransmit interval, in seconds, for link-state advertisements. The default retransmit-interval is 5.
transit-delay <1-1800>: Specifies the transit-delay interval, in seconds, required to transmit a link-state update packet over the virtual interface. The default transit-delay is 1.

Default

The default is disabled.

Command Mode

OSPF Router Configuration