l2 tracetree

Trigger a Layer 2 tracetree. Layer 2 tracetree allows a user to trigger a multicast link trace message (LTM) by specifying the Backbone VLAN (B-VLAN) and service instance identifier (I-SID). The command allows the user to view a multicast tree on the SPBM B-VLAN from the source node to the destination nodes for a particular I-SID.

Syntax

l2 tracetree <1-4059> <1-16777215>
l2 tracetree <1-4059> <1-16777215> mac 0x00:0x00:0x00:0x00:0x00:0x00
l2 tracetree <1-4059> <1-16777215> mac 0x00:0x00:0x00:0x00:0x00:0x00 priority <0-7>
l2 tracetree <1-4059> <1-16777215> priority <0-7>
l2 tracetree <1-4059> <1-16777215> routernodename WORD<0-255>
l2 tracetree <1-4059> <1-16777215> routernodename WORD<0-255> priority <0-7>
l2 tracetree <1-4059> <1-16777215> routernodename WORD<0-255> source-mode nodal ttl-value <1-255>
l2 tracetree <1-4059> <1-16777215> routernodename WORD<0-255> source-mode smltVirtual ttl-value <1-255>
l2 tracetree <1-4059> <1-16777215> routernodename WORD<0-255> ttl-value <1-255>
l2 tracetree <1-4059> <1-16777215> source-mode nodal ttl-value <1-255>
l2 tracetree <1-4059> <1-16777215> source-mode smltVirtual ttl-value <1-255>
l2 tracetree <1-4059> <1-16777215> ttl-value <1-255>

Command Parameters

<1-16777215>: Specifies the service instance identifier (I-SID).
<1-4059>: Specifies the VLAN ID in the range of 1 to 4059. By default, VLAN IDs 1 to 4059 are configurable and the system reserves VLAN IDs 4060 to 4094 for internal use. On switches that support the vrf-scaling and spbm-config-mode boot configuration flags, if you enable these flags, the system also reserves VLAN IDs 3500 to 3998. VLAN ID 1 is the default VLAN and you cannot create or delete VLAN ID 1.
mac <0x00:0x00:0x00:0x00:0x00:0x00>: Specifies the MAC address.
priority <0-7>: Specifies the priority value. The default is 7.
routernodename WORD<0-255>: Specifies the router node name.
source-mode nodal: Specifies the source mode of nodal. The default is nodal.
source-mode smltVirtual: Specifies the source mode of smltVirtual. The default is nodal.
ttl-value <1-255>: Specifies the time-to-live (TTL) value. The default is 64.

Default

None

Command Mode

User EXEC

Usage Guidelines

The source-mode smltVirtual parameter is not supported on 5320 Series.