area range

Use aggregate area ranges to reduce the number of link-state advertisements that are required within the area. You can also control advertisements.

Syntax

area range {A.B.C.D} {A.B.C.D/X} { summary-link | nssa-extlink } advertise-metric <0-65535>
area range {A.B.C.D} {A.B.C.D/X} { summary-link | nssa-extlink } advertise-mode { summarize | suppress | no-summarize }
default area range {A.B.C.D} {A.B.C.D/X} { summary-link | nssa-extlink }
default area range {A.B.C.D} {A.B.C.D/X} { summary-link | nssa-extlink } advertise-metric
default area range {A.B.C.D} {A.B.C.D/X} { summary-link | nssa-extlink } advertise-mode
no area range {A.B.C.D} {A.B.C.D/X} { summary-link | nssa-extlink }

<A.B.C.D> <A.B.C.D/X>: <A.B.C.D> identifies an OSPF area and <A.B.C.DX> is the IP address and subnet mask of the range, respectively.
<summary-link|nssaextlink>: Specifies the LSA type. If you configure the range as type nssaextlink then you cannot configure the advertise-metric.
advertise-metric <0-65535>: Changes the advertised metric cost of the OSPF area range.
advertise-mode <summarize|suppress|nosummarize: Changes the advertisement mode of the range.

None

OSPF Router Configuration