ip igmp query-max-response (for a port)

Syntax

• default ip igmp query-max-response

• ip igmp query-max-response <0-255>

Command Parameters

<0-255>

Configures the maximum response time (in tenths of a second) advertised in IGMPv2 general queries on this interface. Smaller values enables a router to prune groups faster.

Important

You must configure this value lower than the query-interval. The default is 100 tenths of a second (equal to 10 seconds).

Note

You cannot configure this value for IGMPv1.

Default

The default is 100 tenths of a second (equal to 10 seconds).

Command Mode

GigabitEthernet Interface Configuration