show ipv6 dhcp-relay fwd-path

Display information about the IPv6 Dynamic Host Configuration Protocol (DHCP) relay forward paths.

Syntax

show ipv6 dhcp-relay fwd-path
show ipv6 dhcp-relay fwd-path [vrf WORD<1-16>]
show ipv6 dhcp-relay fwd-path [vrf WORD<1-16>] [vrfids WORD<0-512>]
show ipv6 dhcp-relay fwd-path [vrfids WORD<0-512>]

Command Parameters

vrf WORD<1-16>: Specifies the name of the VRF.
vrfids <0-512>: Specifies the ID of the VRF. The value is an integer in the range of 0 to 512.

Default

None

Command Mode

User EXEC

Command Output

The show ipv6 dhcp-relay fwd-path command displays the following information:


Output field	Description
INTERFACE	Shows the VLAN or port associated with the respective relay interface.
SERVER	Specifies the server address.
ENABLE	Specifies if the IPv6 DHCP-relay forwarding path from the client to the server is enabled on the switch.

Example

Switch:1(config-if)#show ipv6 dhcp-relay fwd-path     

================================================================================
                         DHCPv6 Fwd-path - GlobalRouter
================================================================================
INTERFACE                           SERVER                              ENABLE    
--------------------------------------------------------------------------------
1111:0:0:0:0:0:0:1111               1234:0:0:0:0:0:0:1234               enable