lacp (globally)

Configure Link Aggregation Control Protocol (LACP) parameters globally. When the LACP system priority is set globally, it applies to all LACP-enabled aggregators and ports.

Syntax

default lacp
default lacp aggr-wait-time
default lacp enable
default lacp fast-periodic-time
default lacp slow-periodic-time
default lacp system-priority
default lacp timeout-scale
lacp aggr-wait-time <200-2000>
lacp enable
lacp fast-periodic-time <200-20000>
lacp slow-periodic-time <10000-30000>
lacp smlt-sys-id 0x00:0x00:0x00:0x00:0x00:0x00
lacp system-priority <0-65535>
lacp timeout-scale <2-10>
no lacp
no lacp enable

Command Parameters

aggr-wait-time <200-2000>: Sets the aggregation wait time (in milliseconds) globally. The default value is 2000.
enable: Enables the Link Aggregation Control Protocol (LACP) globally.
fast-periodic-time <200-20000>: Sets the fast-periodic time (in milliseconds) globally. The default is 20000 ms.
slow-periodic-time <10000-30000>: Sets the slow periodic time globally. The default value is 1000 ms.
smlt-sys-id <0x00:0x00:0x00:0x00:0x00:0x00>: Sets the LACP system ID globally. Enter a MAC address in the following format: 0x00:0x00:0x00:0x00:0x00:0x00.
system-priority <0-65535>: Sets the global LACP system priority. The default value is 32768.
timeout-scale <2-10>: Sets the timeout scale globally. The default value is 3.

Default

The default is disabled.

Command Mode

Global Configuration

Usage Guidelines

The smlt-sys-id <0x00:0x00:0x00:0x00:0x00:0x00> parameter is not supported on 5320 Series.