show ipv6 ospf interface

Syntax

• show ipv6 ospf interface [gigabitEthernet {slot/port[sub-port]}] [vlan<1-4059>]

• show ipv6 ospf interface [vrf WORD<1-16>] [vrfids WORD<0-512>]

• show ipv6 ospf interface vrf WORD<1-16>

• show ipv6 ospf interface vrfids WORD<0-512>

Command Parameters

{slot/port[sub-port]}

Identifies a single slot and port. If your platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

vlan <1-4059>

Specifies the VLAN ID in the range of 1 to 4059. By default, VLAN IDs 1 to 4059 are configurable and the system reserves VLAN IDs 4060 to 4094 for internal use. On switches that support the vrf-scaling and spbm-config-mode boot configuration flags, if you enable these flags, the system also reserves VLAN IDs 3500 to 3998. VLAN ID 1 is the default VLAN and you cannot create or delete VLAN ID 1.

vrf <WORD 1-16>

Specifies the VRF name.

vrfids <WORD 0-512>

Specifies VRF IDs.

Default

None

Command Mode

User EXEC