show ip spb–pim–gw interface
Display the SPB-PIM Gateway VLAN interface information
Command Parameters
- {slot/port[/sub-port][-slot/port[/sub-port]][,...]}
- Identifies the slot and port.
{slot/port[/sub-port][-slot/port[/sub-port]][,...]} identifies the slot and port
in one of the following formats: a single slot and port (slot/port), a range of
slots and ports (slot/port-slot/port), or a series of slots and ports
(slot/port,slot/port,slot/port). If your platform supports channelization and the
port is channelized, you must also specify the sub-port in the format
slot/port/sub-port.
- vlan <1-4059>
-
Specifies the
VLAN ID in the range of 1 to 4059. By default, VLAN IDs 1 to
4059 are configurable and the system reserves VLAN IDs 4060 to
4094 for internal use. On switches that support the vrf-scaling and spbm-config-mode boot configuration flags, if
you enable these flags, the system also reserves VLAN IDs 3500
to 3998. VLAN ID 1 is the default VLAN and you cannot create or
delete VLAN ID 1.
- vrf WORD<1-16>
- Specifies the SPB-PIM Gateway
interface neighbor information for a specific VRF.
- vrfids WORD<0-512>
- Specifies the SPB-PIM Gateway
interface neighbor information for a range of VRF IDs.
