ip bfd (for a loopback)
Enable and configure Bidirectional Forwarding
Detection (BFD) on a loopback interface.
Syntax
-
default ip bfd enable
-
default ip bfd interval
-
default ip bfd min-rx
-
default ip bfd multiplier
-
ip bfd enable
-
ip bfd interval
<100-65335>
-
ip bfd min-rx
<100-65335>
-
ip bfd multiplier
<1-20>
-
ip bfd loopback
<1-256>
-
no ip bfd enable
-
no ip bfd loopback
Command Parameters
- enable
- Enable BFD on a loopback.
- interval
- Specifies the transmit interval in
milliseconds. The default is 200 ms. The minimum value for the transmit interval
is 100 ms. You can configure a maximum of 4 BFD sessions with the minimum value
for the transmit interval. You can configure the remaining BFD sessions with a
transmit interval that is greater than or equal to the 200 ms default value.
- min_rx
- Specifies the receive interval in
milliseconds. The default is 200 ms. The minimum value for the receive interval is
100 ms. You can configure a maximum of 4 BFD sessions with the minimum value for
the receive interval. You can configure the remaining BFD sessions with a receive
interval that is greater than or equal to the 200 ms default value.
- multiplier
- Specifies the multiplier used to
calculate the amount of time BFD waits before it declares a receive timeout. The
default is 3. If you configure the transmit interval or the receive interval as
100 ms, you must configure a value of 4 or greater for the multiplier.
Default
The default is disabled.
Command Mode
Loopback Interface Configuration
Usage Guidelines
This command is not supported on all hardware platforms. For information about feature
support, see Fabric Engine User Guide.
