ipv6 route (for a Management Instance)

Configures an IPv6 static route for a Management Instance.

Syntax

default ipv6 route WORD<0-255> next-hop WORD<0-255> [weight]
ipv6 route WORD<0-255> [next-hop WORD<0-255>] [weight <1-65535>]
no ipv6 route WORD<0-255> next-hop WORD<0-255> [weight]

Command Parameters

next-hop WORD<0-255>: Specifies the next hop address for the static route. Use an IP in the same subnet as the management VLAN IP address.
weight <1-65535>: Specifies the static route cost. The default is 200.
WORD<0-255>: Specifies the address and prefix length.

Default

None

Command Mode

Management Instance Configuration

Usage Guidelines

For the Management Instance CLIP, you do not need to configure a default or static route. This interface type uses all routing information learned by protocols attached to the VRF. For more information about how to associate a VRF with the CLIP interface, see mgmt clip.

For the Management Instance OOB and VLAN, you must configure a default or static route to reach the next-hop gateway; no routing protocol information is used to access off-link networks.