show ipv6 nd-prefix

View all configured neighbor discovery prefixes.

Syntax

show ipv6 nd-prefix [detail]
show ipv6 nd-prefix detail vrf WORD<1-16>
show ipv6 nd-prefix detail vrfids WORD<0-512>
show ipv6 nd-prefix interface gigabitethernet [{slot/port[/sub-port][-slot/port[/sub-port]][,...]}]
show ipv6 nd-prefix interface vlan [<1-4059>]
show ipv6 nd-prefix vlan [<1-4059>]
show ipv6 nd-prefix vrf WORD<1-16>
show ipv6 nd-prefix vrfids WORD<0-512>

detail: Shows detailed information.
gigabitEthernet {slot/port[/sub-port][-slot/port[/sub-port]][,...]}: Identifies the slot and port in one of the following formats: a single slot and port (slot/port), a range of slots and ports (slot/port-slot/port), or a series of slots and ports (slot/port,slot/port,slot/port). If your platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.
vlan <1-4059>: Specifies the VLAN ID in the range of 1 to 4059. By default, VLAN IDs 1 to 4059 are configurable and the system reserves VLAN IDs 4060 to 4094 for internal use. On switches that support the vrf-scaling and spbm-config-mode boot configuration flags, if you enable these flags, the system also reserves VLAN IDs 3500 to 3998. VLAN ID 1 is the default VLAN and you cannot create or delete VLAN ID 1.
vrf WORD<1-16>: Specifies a VRF name. The VRF parameter is optional.
vrfids WORD<0-512>: Specifies a VRF by ID. The VRF parameter is optional.

None

User EXEC