show ip vrrp interface

Display Virtual Router Redundancy Protocol (VRRP) information about the interface.


Command Parameters

[version <2|3>
Displays the VRRP version configured.
gigabitEthernet {slot/port[/sub-port][-slot/port[/sub-port]][,...]}
Identifies the slot and port in one of the following formats: a single slot and port (slot/port), a range of slots and ports (slot/port-slot/port), or a series of slots and ports (slot/port,slot/port,slot/port). If your platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.
Shows all available information about the VRRP interfaces.
vlan <1-4059>
Shows the VRRP interface gigabitEthernet configurations. Specifies the VLAN ID in the range of 1 to 4059. By default, VLAN IDs 1 to 4059 are configurable and the system reserves VLAN IDs 4060 to 4094 for internal use. If you enable VRF scaling and SPBM mode, the system also reserves VLAN IDs 3500 to 3998. VLAN ID 1 is the default VLAN and you cannot create or delete VLAN ID 1.
vrf WORD<1-16>
Shows all available information about the VRRP interfaces.
vrfids WORD<0-512>
Specifies the ID of the VRF.



Command Mode