ip igmp access-list mode (for a port)

Changes the mode for an existing access list on the Ethernet port.


Command Parameters

Creates an access control group entry for a specific Internet Group Management Protocol (IGMP) interface. Specifies the IP address of the host and the subnet mask used to determine the host or hosts covered by this configuration. You can use the host subnet mask to restrict access to a portion of the network for the host.
deny-tx | deny-rx | deny-both | allowonly-tx | allowonly-rx | allowonly-both
Indicates the action for the specified Internet Group Management Protocol (IGMP) interface. For example, if you specify deny-both, the interface denies both transmitted and received traffic.
Specifies the name of the access list from 1-64 characters.



Command Mode

GigabitEthernet Interface Configuration