ip vrf

Creates a VRF instance.

Syntax

Command Parameters

ipv6-max-routes <0-7744>

Specifies the maximum number of IPv6 routes for the VRF. Depending on the hardware platform, the parameter range and default value can vary. Use the CLI Help to see the available range for the switch. For route scaling information, see Fabric Engine Release Notes.

ipv6-max-routes-trap enable
Enables SNMP trap generation based on the configured number of maximum IPv6 routes.
max-routes <max-routes>

Specifies the maximum number of IPv4 routes for the VRF. Depending on the hardware platform, the parameter range and default value can vary. Use the CLI Help to see the available range for the switch. For route scaling information, see Fabric Engine Release Notes.

max-routes-trap enable
Enables the sending of traps after the maximum number of routes is reached. The default is enabled.
name WORD<1-16>
Renames the VRF instance.
vrfid <1-511>
Specifies a VRF ID. The switch supports 512 VRFs.
vrf-trap enable
Enables the device to send VRF-related traps. The default is enabled.
WORD<1-16>
Specifies the name for the VRF.

Default

None

Command Mode

Global Configuration

Usage Guidelines

This command does not apply to all hardware platforms. For more information about feature support, see Fabric Engine Feature Support Matrix.