auto-negotiate (for the management port)

Configure auto-negotiation for the Ethernet management port.

Note

This command does not apply to all hardware platforms.

Syntax

{slot/port[/sub-port] [-slot/port[/sub-port]] [,...]}: Identifies the slot and port in one of the following formats: a single slot and port (slot/port), a range of slots and ports (slot/port-slot/port), or a series of slots and ports (slot/port,slot/port,slot/port). If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

The default is enabled.

mgmtEthernet Interface Configuration

This command is not supported on 5320 Series.