access-policy by-mac

Configure access-policies by MAC address to allow or deny local MAC addresses on the network management port after an access policy is activated. If the source MAC does not match a configured entry, then the default action is taken.


Command Parameters

<0x00:0x00:0x00:0x00: 0x00:0x00> <allow|deny>
Adds a MAC address to the policy. Enter the MAC address in hexadecimal format. Specify the action to take for the MAC address.
action <allow|deny>
Specifies the action for a MAC address that does not match the policy.


The default action is allow.

Command Mode

Global Configuration