sflow collector

Configure an sFlow collector to determine the device to which the sFlow agent sends sFlow datagrams.


Command Parameters

Specifies the ID to export sFlow datagrams to the collector ID.
address {A.B.C.D}
Specifies the collector IP address.
owner WORD<1–20>
Specifies the sFlow collector name.
port <1–65535>
Specifies the destination UDP port. The default port is 6343.
timeout <1–65535>
Specifies the time remaining (in seconds) before the collector is released. The default is 0, which means you are not using the collector.
Specifies the name of the VRF used to reach the collector.



Command Mode

Global Configuration