ipv6 neighbor (for VRF)

Comands to configure IPv6 neighbors globally.


Command Parameters

mac 0x00:0x00:0x00:0x00:0x00:0x00
Specifies the MAC address.
port {slot/port[sub-port]}
Identifies a single slot and port. If your platform supports channelization and the port is channelized, you must also specify the subport in the format slot/port/sub-port.
vlan <1-4059>

Specifies the VLAN ID in the range of 0 to 4059. By default, VLAN IDs 1 to 4059 are configurable and the system reserves VLAN IDs 4060 to 4094 for internal use. On switches that support the vrf-scaling and spbm-config-mode boot configuration flags, if you enable these flags, the system also reserves VLAN IDs 3500 to 3998. VLAN ID 1 is the default VLAN and you cannot create or delete VLAN ID 1.

Ipv6 address in hex colon format.



Command Mode

VRF Router Configuration