ip dhcp-relay fwd-path {A.B.C.D} src-port-67 (for a VLAN)

Configure a forwarding path with source port 67 in a User Datagram Protocol (UDP) on a VLAN.

Syntax

Command Parameters

{A.B.C.D}
Creates a forwarding path to the DHCP server with a mode and a state. A.B.C.D is the IP address of the server. The default IP address of the relay is the address of the interface.
Tip

Tip

If the relay is a Virtual Router configured on this interface, you must set the vrid.

src-port-67
Specifies that the UDP source port is 67 for BOOTP request. The default is 68.

Default

None

Command Mode

VLAN Interface Configuration

Usage Guidelines

This command does not apply to all hardware platforms. For more information about feature support, see Fabric Engine Feature Support Matrix.