duplex (for the management port)

Syntax

• default duplex [port {slot/port[/sub-port][-slot/port[/sub-port]][,...]}]

• duplex [port {slot/port[/sub-port][-slot/port[/sub-port]][,...]}]<half|full>

Command Parameters

<half|full>

Specifies half- or full-duplex mode. 1 and 10 Gb/s ports must use full-duplex mode.

port {slot/port[/sub-port] [-slot/port[/sub-port]] [,...]}

Identifies the slot and port in one of the following formats: a single slot and port (slot/port), a range of slots and ports (slot/port-slot/port), or a series of slots and ports (slot/port,slot/port,slot/port). If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

Default

The default is half-duplex mode.

Command Mode

mgmtEthernet Interface Configuration

Usage Guidelines

This command is not supported on 5320 Series.