ip igmp flush vlan

Use this command to flush Internet Group Management Protocol (IGMP) group members, the multicast router and senders.


Command Parameters


Specifies the VLAN ID in the range of 1 to 4059. By default, VLAN IDs 1 to 4059 are configurable and the system reserves VLAN IDs 4060 to 4094 for internal use. On switches that support the vrf-scaling and spbm-config-mode boot configuration flags, if you enable these flags, the system also reserves VLAN IDs 3500 to 3998. VLAN ID 1 is the default VLAN and you cannot create or delete VLAN ID 1.

Specifies a group member.
Specifies a multicast router.
sender {A.B.C.D} {A.B.C.D}
Specifies a sender. The first IP address specifies the source IP address of the sender. The second IP address specifies the group IP address of the sender.



Command Mode