show ipv6 ospf lsdb

Show the IPv6 OSPFv3 Link-state database configuration.


Command Parameters

adv-rtr {A.B.C.D}
Specifies the advertise router configurations.
area {A.B.C.D}
Specifies the ipv6 lsdb area configurations.
gigabitEthernet {slot/port[sub-port]}
Identifies a single slot and port. If your platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.
Specifies the ipv6 ospf lsdb interface configurations.
lsa-type <1-11>
Specifies the ipv6 ospf lsdb lsa-type.
lsid <0-4294967295>
Specifies the ospf lsdb configuration for specific lsid.
scope <1-3>
Specifies the ipv6 ospf lsdb scope.
tunnel <1-2000>
Specifies the ipv6 ospf lsdb tunnel parameters.
vlan <1-4059>

Specifies the VLAN ID in the range of 1 to 4059. By default, VLAN IDs 1 to 4059 are configurable and the system reserves VLAN IDs 4060 to 4094 for internal use. On switches that support the vrf-scaling and spbm-config-mode boot configuration flags, if you enable these flags, the system also reserves VLAN IDs 3500 to 3998. VLAN ID 1 is the default VLAN and you cannot create or delete VLAN ID 1.

vrf <WORD 1-16>
Specifies the VRF name.
vrfids <WORD 0-512>
Specifies VRF IDs.



Command Mode