lldp port

Configures LLDP on a port or ports.


Command Parameters


Identifies the slot and port in one of the following formats: a single slot and port (slot/port), a range of slots and ports (slot/port-slot/port), or a series of slots and ports (slot/port,slot/port,slot/port). If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

Enables Cisco discovery protocol on the selected port(s) to accept CDP packets only.
The default is disabled.
status <txAndrx>

Specifies LLDP frames to transmit and receive on the selected port(s).

The default is enabled.


The default is none.

Command Mode

GigabitEthernet Interface Configuration