mgmt dhcp-client

Syntax

• mgmt dhcp-client {cycle | oob | vlan}

• no mgmt dhcp-client

Command Parameters

cycle

Specifies the DHCP Client to attempt to obtain an IP address on the In-Band VLAN management interface, then the Out-of-Band management interface. Cycle attempts until an IP address is obtained.

oob

Specifies the DHCP Client to obtain an IP address for the Out-of-Band management interface.

vlan

Specifies the DHCP Client to obtain an IP address for the In-Band VLAN management interface.

Default

The DHCP Client for management interfaces is disabled.

Note

Exception: the DHCP Client is enabled by default in cycle mode when:

• The switch ships directly from manufacturing with VOSS Release 8.1.60 or later.

• The primary and secondary configuration file is not on the switch.

• The primary and secondary configuration file fail to load on the switch.

Command Mode

Global Configuration

Usage Guidelines

The cycle and oob parameters are not supported on 5320 Series.