Configure MultiLink Trunking (MLT) to set up MLTs on the switch.


Command Parameters

Specifies the MLT ID in the range of 1-512.
Creates and enables a new MLT.
encapsulation dot1q
Sets encapsulation. dot1q enables trunking on the MLT.
name <0-20>
Changes the name for this MLT in the range of 0-20 characters.
private-vlan {isolated|promiscuous|trunk}
Specifies the private VLAN port type for this MLT.
vlan <1-4059>

Specifies the VLAN ID in the range of 1 to 4059. By default, VLAN IDs 1 to 4059 are configurable and the system reserves VLAN IDs 4060 to 4094 for internal use. On switches that support the vrf-scaling and spbm-config-mode boot configuration flags, if you enable these flags, the system also reserves VLAN IDs 3500 to 3998. VLAN ID 1 is the default VLAN and you cannot create or delete VLAN ID 1.



Command Mode

Global Configuration

Usage Guidelines

You cannot configure an MLT name that uses all numbers, for example, 222.