Removing a Unit from the Stack
Use the following steps to remove a switch from
the stack:
-
Make sure the redundant stack connection is in place and functional. All stack members should be connected in a logical ring.
-
Power down the unit to be removed.
-
Disconnect the stacking cables
-
If the unit is not to be replaced, reconnect the stack cable from the stack member above to the stack member below the unit being removed.
-
Remove the unit from the rack.
-
If desired, remove the unit from the configuration by issuing the command no member unit-id in Stack mode.
Using the web Interface, you can remove a member
of the stack by selecting Then check the box next to the switch and click Remove.