Use the SNTP Source Interface Configuration page to specify the physical or logical interface to use as the SNTP (Simple Network Time Protocol) client source interface. When an IP address is configured on the source interface, this address is used for all SNTP communications between the local SNTP client and the remote SNTP server. The IP address of the designated source interface is used in the IP header of SNTP management protocol packets. This allows security devices, such as firewalls, to identify all source packets coming from a specific device.
To access this page, click
in the navigation menu.Field | Description |
---|---|
Type | The type of interface to use as the source interface:
|
Interface | When the selected Type is Interface, select the physical port to use as the source interface. |
Loopback Interface | When the selected Type is Loopback, select the loopback interface to use as the source interface. |
VLAN ID | When the selected Type is VLAN, select the VLAN to use as the source interface. The menu contains only the VLAN IDs for VLAN routing interfaces. |
Tunnel ID | When the selected Type is Tunnel, select the tunnel interface to use as the source interface. |
Click Refresh to display the latest information from the switch.
If you change any of the parameters, click Submit to apply the changes to the system. If you want the switch to retain the new values across a power cycle, you must save the configuration.