Use the Email Alert Global Configuration page to configure the common settings for log messages emailed by the switch.
To access this page, click
in the navigation menu.Field | Description |
---|---|
Admin Mode | Sets the administrative mode of the feature.
|
From Address | Specifies the email address of the sender (the switch). |
Log Duration | This duration in minutes determines how frequently the non critical messages are sent to the SMTP Server. |
Urgent Messages Severity | Configures the
severity level for log messages that are considered to be urgent. Messages in
this category are sent immediately. The security level you select and all
higher levels are urgent:
|
Non Urgent Messages Severity | Configures the severity level for log messages that are
considered to be nonurgent. Messages in this category are collected and sent in
a digest form at the time interval specified by the Log Duration field. The
security level you select and all levels up to, but not including the lowest
Urgent level are considered nonurgent. Messages below the security level you
specify are not sent via email. See the Urgent Message field description for information about the security levels. |
Traps Severity | Configures the severity level for trap log messages. See the Urgent Message field description for information about the security levels. |
If you change any of the parameters, click Submit to apply the changes to the system. If you want the switch to retain the new values across a power cycle, you must save the configuration.
After configuring all email alert settings, click Test to send a test message to the configured address(es).