wireless-client

Configures wireless client parameters on this radio

Supported in the following platforms:

Access Points — AP3000/X, AP5010, AP310i/e, AP410i/e, AP460i/e, AP505i, AP510i/e, AP560i/h, AP7522, AP7532, AP7562, AP7612, AP7632, AP7662, AP8432, AP8533

Syntax

wireless-client tx-power [<0-20>|mode]

wireless-client <0-20>

wireless-client tx-power mode [802.11d {wing-ie}|wing-ie {802.11d}]

Parameters

wireless-client tx-power <0-20>


wireless-client	Configures wireless client parameters
tx-power <0-20>	Configures the transmit power indicated to wireless clients. If using a dual or three radio model access point, each radio should be configured with a unique transmit power in respect to its intended client support function. A setting of 0 defines the radio as using Smart RF to determine its output power. 20 dBm is the default value. <0-20> – Specify transmit power from 0 - 20 dBm.

wireless-client tx-power mode [802.11d {wing-ie}|wing-ie {802.11d}]


wireless-client	Configures wireless client parameters
tx-power [802.11d\|wing-ie]	Configures the transmit power indicated to wireless clients 802.11d – Advertises in the IEEE 802.11d country information element wing-ie – Optional. Advertises in the WiNG information element (173) wing-ie – Advertises in the WiNG information element (173). This is the default setting. 802.11d – Optional. Advertises in the IEEE 802.11d country information element

Example

nx9500-6C8809(config-profile-510TestProfile-if-radio1)#wireless-client tx-power 20

nx9500-6C8809(config-profile-510TestProfile-if-radio1)#show context
 interface radio1
  rf-mode sensor
  placement outdoor
  mesh client
  rts-threshold 100
  wireless-client tx-power 20
  off-channel-scan channel-list 2.4GHz 1
  guard-interval long
  aggregation ampdu tx-only
   --More--
nx9500-6C8809(config-profile-510TestProfile-if-radio1)#

Related Commands


no (radio-interface-config-command)	Resets the transmit power indicated to wireless clients