reload
Displays scheduled reload information for a specific
device
Note
This command is not present in the USER EXEC
mode.
Supported on the following devices:
- Access Points: AP3000/X, AP5010, AP310i/e, AP410i/e, AP505i, AP510i, AP510e, AP560i, AP6522, AP6562, AP7161, AP7502,
AP7522, AP7532, AP7562, AP7602, AP7612, AP7622, AP763, AP7662, AP8163, AP8543,
AP8533.
- Service Platforms:
NX5500, NX7500, NX9500, NX9600
- Virtual Platforms: CX9000, VX9000
Syntax
show reload {on <DEVICE-OR-DOMAIN-NAME>}
Parameters
show reload {on <DEVICE-OR-DOMAIN-NAME>}
| reload {on <DEVICE-OR-DOMAIN-NAME>} |
Displays scheduled reload information for a specified device
- on
<DEVICE-OR-DOMAIN-NAME> – Optional. Displays configuration on a
specified device
- <DEVICE-OR-DOMAIN-NAME> – Specify the name of the AP,
wireless controller, service platform, or RF Domain.
|
Examples
nx9500-6C8809(config)#show reload
No reload is scheduled.
nx9500-6C8809(config)#
