route-limit
Limits the number of routes managed by
OSPF. The maximum limit supported by the platform is the default configuration defined
under the router-ospf context.
Supported in the following platforms:
- Access Points — AP410i/e, AP460i/e,
AP505i, AP510i/e, AP560i/h, AP7522, AP7532, AP7562, AP7612, AP7632, AP7662, AP8432,
AP8533
Syntax
route-limit [num-routes|reset-time|retry-count|retry-timeout]
route-limit [num-routes <DYNAMIC-ROUTE-LIMIT>|reset-time <1-86400>|retry-count <1-32>|
retry-timeout <1-3600>] {(num-routes|reset-time|retry-count|retry-timeout)}
Parameters
route-limit [num-routes <DYNAMIC-ROUTE-LIMIT>|reset-time <1-86400>|retry-count <1-32>|
retry-timeout <1-3600>] {(num-routes|reset-time|retry-count|retry-timeout)}
| num-routes <DYNAMIC-ROUTE-LIMIT> |
Specifies the maximum number of non self-generated LSAs this process can
receive
- <DYNAMIC-ROUTE-LIMIT> – Specify the dynamic route limit.
|
| reset-time <1-86400> |
Specifies the time, in seconds, after which the retry-count is reset to
zero
- <1-86400> –
Specify a value from 1 - 86400 seconds. The default is 360
seconds.
|
| retry-count <1-32> |
Specifies the maximum number of times adjacencies can be suppressed.
Each time OSPF gets into an ignore state, a counter increments. If the
counter exceeds the timeout configured by the retry-count parameter, OSPF
stays in the same ignore state. Manual intervention is required to get OSPF
out of the ignore state.
- <1-32> – Specify
a value from 1 - 32. The default is 5.
|
| retry-timeout <1-3600> |
Specifies the retry time in seconds. During this time, OSPF remains in
ignore state and all adjacencies are suppressed.
- <1-3600> –
Specify a value from 1 - 3600 seconds. The default is 60 seconds.
|
Examples
nx9500-6C8809(config-profile default-ap8533-router-ospf)#route-limit num-routes 10
retry-count 5 retry-timeout 60 reset-time 10
nx9500-6C8809(config-profile default-ap8533-router-ospf)#show context
router ospf
ospf enable
network 1.2.3.0/24 area 4.5.6.7
area 0.0.0.4
auto-cost reference-bandwidth 1
default-information originate metric 1 metric-type 2
redistribute static metric-type 1
passive vlan1
route-limit num-routes 10 retry-count 5 retry-timeout 60 reset-time 10
ip default-gateway priority 1
nx9500-6C8809(config-profile default-ap8533-router-ospf)#
