Configuring SNMPv1/v2c-specific Parameters

1. Configure the following parameters on the SNMPv1/v2c tab:
   • Read Community Name — The password that is used for read-only SNMP (Simple Network Management Protocol) communication.
   • Read/Write Community Name — The password that is used for write SNMP communication.
   • Manager A — The IP address of the server used as the primary network manager that will receive SNMP messages.
   • Manager B — The IP address of the server used as the secondary network manager that will receive SNMP messages.
     

     Note

     Manager A and Manager B address fields support both IPv4 or IPv6 addresses.
2. Click Save.